Dell 8 - Page 224

224 Installing Blade Components
4 Lift up on the left side of the impedance wall to release it from the chassis
inner wall, then slide the impedance wall out of the slot on the expansion-
card riser. See Figure 3-35.
5 Lift the expansion-card riser off the riser guide posts and out of the system.
See Figure 3-38.
Figure 3-38. Installing or Removing the Expansion-Card Riser (PowerEdge M610x Only)
1 expansion-card riser 2 riser guide (2)
3 expansion-card slot 1 4 expansion-card slot 2
5 riser guide post (2) 6 power cable connector
7 data cable connector (2 front, 2 back)
1
4
3
5
6
7
2