Dell Alienware Aurora R8 - Removing the Stability Foot; Procedure

Removing the stability foot
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in Before working inside your computer. After working inside your computer, follow the instructions
in
After working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1 Place the computer on a clean and at surface with the bottom cover facing up.
2 Pull the securing tab to release the stability foot from the slots on the bottom cover.
3 Lift the stability foot o the bottom cover.
4 Lay the computer on its side.
17