Dell Alienware Aurora R8 - Replacing the Stability Foot; Procedure

Replacing the stability foot
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in Before working inside your computer. After working inside your computer, follow the instructions
in
After working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1 Place the computer on a clean and at surface with the bottom cover facing up.
2 Align the tabs on the stability foot with the slots on the bottom cover and snap the stability foot to lock it in place.
3 Turn the computer over and place it in upright position.
18