Next steps
1 Install the battery.
2 Install the base cover.
3 Install the microSD card.
4 Follow the procedure in after working inside your computer.
Input Output board
Removing the Input and output board
Prerequisites
1 Follow the procedure in before working inside your computer.
2 Remove the microSD card.
3 Remove the base cover.
4 Remove the battery.
Steps
1 Disconnect the Type-C power cable from the connector in the IO board [1].
2 Open the latch and disconnect the 30-pin and 40-pin IO board cable from the connectors in the IO board [2].
Removing and Installing
31
To Next Page
Loading...
