4 Pull the keyboard cable from the gap in the palmrest and connect to the connector on the keyboard interposer board [1, 2].
Next steps
1 Install the battery.
2 Install the base cover.
3 Install the microSD card.
4 Follow the procedure in after working inside your computer.
System board
Removing the system board
Prerequisites
1 Follow the procedure in before working inside your computer.
2 Remove the microSD card.
3 Remove the base cover.
4 Remove the battery.
Steps
1 Remove the single (M2.0x3.0) screw that secures the wireless bracket to the system board [1].
2 Lift the wireless bracket away from the computer [2].
3 Disconnect the two wireless antennas from the connector on the system board [3].
Removing and Installing
45
To Next Page
Loading...
