Next steps
1 Install the battery.
2 Install the base cover.
3 Install the microSD card.
4 Follow the procedure in after working inside your computer.
Display assembly
Removing display assembly
Prerequisites
1 Follow the procedure in before working inside your computer.
2 Remove the microSD card.
3 Remove the base cover.
4 Remove the battery.
Steps
1 Remove the single (M2.0x3.0) screw that secures the wireless bracket to the system board [1].
2 Lift the wireless bracket away from the computer [2].
3 Disconnect and unroute the two wireless antennas from the connector on the system board [3].
Removing and Installing
55
To Next Page
Loading...
