7 Remove the display panel.
Steps
1 Peel the adhesive tape that covers the camera cable connector [1].
2 Disconnect the camera cable from the camera module and unroute the cable [2, 3].
3 Peel the adhesive tape that secures the display cable and lift the display cable away from the display back cover and antenna
assembly.
Installing display cable
Steps
1 Ax the adhesive tape to secure the display cable to the display back coverand route the cable [1].
2 Connect the camera cable connector to the camera module [2].
3 Ax the adhesive tape to secure the camera cable connector [3].
Removing and Installing
73