NOTE: The screw securing the display cable bracket also secures the left IO bracket to the system board, as a result
removal of the display cable bracket leaves the left IO bracket unsecured. Technicians should therefore ensure that the
left IO bracket is not moved or lost during any subsequent disassembly processes.
8 Open the system to 180 degrees and place the computer on a at surface, with the display hinges facing up.
9 Remove the six (M2.5x5.0) screws that secure the display assembly to the palmrest [1].
10 Remove the display assembly from the plamrest [2].
Removing and Installing
57
To Next Page
Loading...
