Installing front input and output panel
1. Insert the input and output(I/O) panel onto its slot in the system.
2. Slide the panel to secure the hooks into the chassis hole.
3. Tighten the screw to secure the front I/O panel to the chassis.
4. Connect the following cables:
• intrusion switch cable
• USB 3.1 cable
• front I/O power cable
• front I/O power cable
• USB 3.1 cable
• speaker cable
• audio cable
5. Install the:
a. front input and output bezel
b. 5.25 inch ODD bracket
c. front bezel
d. side cover
6. Follow the procedure in After working inside your computer.
Removing and installing components
43
To Next Page
Loading...
