Dell D18M - 2.5-Inch Hard Drive Assembly; Removing the 2.5-Inch Drive Assembly; Installing the 2.5-Inch Drive Assembly

To Next Page

To Previous Page

2.5-inch hard drive assembly

Removing the 2.5–inch drive assembly

1. Follow the procedure in Before working inside your computer.

2. Remove the:

a. side cover

b. front bezel

3. Open the front panel door.

4. To remove the drive assembly:

a. Disconnect the drive assembly cables from the connectors on the drive [1] .

b. Press the blue tabs on both sides [2] and pull the drive assembly out of the computer [3].

NOTE: Gently press the blue tabs to avoid damage to the plastic tabs.

Installing the 2.5-inch drive assembly

1. Insert the drive assembly into the slot on the computer and press until it clicks into place [1,2].

2. Connect the SATA cable and the power cable to the connectors on the drive [3].

Disassembly and reassembly

Other manuals for Dell D18M