Dell Dimension V350 - Expansion, EIDE, and Drive Options

1-6 Dell Dimension V xxx and V xxx c Systems Service Manual
$GYDQFHG([SDQVLRQ6XEV\VWHP
This computer system offers an advanced expansion subsystem that can sup-
port a mixture of traditional ISA expansion cards (called
legacy expansion
cards), Plug and Play ISA expansion cards, and PCI expansion cards. Using the
operating system, you can configure the various types of expansion cards and
identify resource conflicts that might arise.
The expansion-card slots include two ISA expansion-card connectors and three
PCI expansion-card connectors. One PCI expansion-card connector and one
ISA expansion-card connector share a single expansion-card slot, so users can
install a maximum of four expansion cards.
(,'(6XEV\VWHP
The EIDE subsystem includes two EIDE interfaces (primary and secondary),
each of which can support up to two EIDE devices such as high-capacity hard-
disk drives, CD-ROM drives, and tape drives.
All EIDE devices should be configured for the Cable Select jumper position,
which assigns master and slave status to devices by their position on the inter-
face cable. In this configuration, the drive attached to the last connector on the
interface cable is the master or boot drive (drive 0) and the drive attached to
the middle connector on the interface cable is the slave drive (drive 1). Refer to
the drive’s documentation for instructions on setting the Cable Select jumper
position.
NOTE: The externally accessible drive bays at the front of the computer are
normally used for diskette drives, CD-ROM drives, or tape drives. The hard-disk
drives should be installed in the internal drive bays as described in the
following subsection. For detailed information about the data storage sub-
system, see Chapter 3, “Installing Drives,” in the
Dell Dimension V xxx and
V
xxx c Reference and Troubleshooting Guide .
+DUG'LVN'ULYH2SWLRQV
A 1-inch-high EIDE hard-disk drive is installed in the primary hard-disk drive bay
in the card-guide assembly at the front of the chassis. An optional 1-inch-high
EIDE hard-disk drive can be installed in the secondary hard-disk drive bay
located near the 3.5-inch diskette drive.
&RPSXWHU6HUYLFH
The following subsections provide service-related information about the
computer.