4-14 Dell Dimension V
xxx
and V
xxx
c Systems Service Manual
6HFRQGDU\+DUG'LVN'ULYH
)LJXUH 6HFRQGDU\ +DUG'LVN 'ULYH $VVHPEO\ 5HPRYDO
To remove a secondary hard-disk drive, follow these steps:
1. Remove the bezel.
2. Disconnect the DC power and interface cables from the back of the sec-
ondary hard-disk drive.
3. Remove the two drive-assembly mounting screws (see Figure 4-12).
4. Slide the secondary hard-disk drive assembly toward the back of the
chassis, and lift it out.
To reinstall the hard-disk drive assembly, be sure that the rails on the
assembly slide into the grooves of the card guide assembly.
5. To remove the secondary hard-disk drive from the drive bracket, remove
the screw securing the drive to the bracket and rotate the drive out of the
bracket, as shown in Figure 4-13.
secondary hard-disk drive assembly
drive-assembly
mounting screws (2)
card guide assembly
To Next Page
Loading...
