System Setup Program A-5
3HULSKHUDO&RQILJXUDWLRQ6XEPHQX
)LJXUH $ 3HULSKHUDO &RQILJXUDWLRQ 6XEPHQX
7DEOH $ 3HULSKHUDO &RQILJXUDWLRQ 6XEPHQX 2SWLRQV
2SWLRQ )XQFWLRQ
Serial port A Configures the serial port. Set this option to Auto
(default), Enabled, or Disabled. If set to
Enabled, you can set the following additional
options:
Base I/O
Address
Available I/O addresses are COM1, COM2,
COM3, and COM4.
Interrupt Available interrupts are IRQ3 and IRQ4.
Parallel port Configures the parallel port. Set this option to
Auto (default), Enabled, or Disabled. Depending
on the port setting, you can set the following
additional options:
Mode If port is set to Auto or Enabled, available modes
are Output Only, Bi-Directional, ECP, and EPP.
NOTE: Refer to the device manufacturer's docu-
mentation for information on which mode to use
before changing this setting.
Base I/O
Address
If port is set to Enabled, available I/O addresses
are 378h (default), 278h, 3BC, and 228h.
Interrupt If port is set to Enabled, available interrupts are
IRQ7 and IRQ5.
NOTE: The Glossary in the
Online Guide
defines abbreviations and acronyms.
To Next Page
Loading...
