System Setup Program A-7
7DEOH $ ,'( &RQILJXUDWLRQ 6XEPHQX 2SWLRQV
2SWLRQ )XQFWLRQ
IDE controller Configures the integrated primary and secondary
EIDE controllers and detects the types of drives
attached to them. If set to Primary, Secondary,
or Both, the designated controller(s) are enabled,
and the types of drives attached are displayed. If
set to either Primary or Secondary, the other
controller is not enabled and the IRQ it normally
uses becomes available. If set to Disabled, the
system cannot detect any drives attached to the
controllers and displays None for all four IDE
drive options.
Primary IDE
Master
Identifies the first drive attached to the primary
EIDE interface, usually the boot hard-disk drive.
Refer to “Primary IDE Master Submenu” found
next in this appendix.
Primary IDE
Slave
Identifies the second drive attached to the
primary EIDE interface, usually a second hard-
disk drive. The format of this submenu is the
same as the one described in “Primary IDE Mas-
ter Submenu” found next in this appendix.
Secondary
IDE Master
Identifies the first drive attached to the secondary
EIDE interface, usually a CD-ROM or tape drive.
The format of this submenu is the same as the
one described in “Primary IDE Master Submenu”
found next in this appendix.
Secondary
IDE Slave
Identifies the second drive attached to the sec-
ondary EIDE interface, usually a CD-ROM or tape
drive. The format of this submenu is the same as
the one described in “Primary IDE Master Sub-
menu” found next in this appendix.
NOTE: The Glossary in the
Online Guide
defines abbreviations and acronyms.
To Next Page
Loading...
