Figure 58 Removing an internal SD card
a. IDSDM
b. SD card 1
c. SD card 2
d. SD card slot 2
e. SD card slot 1
After you finish
Follow the procedure listed in the After working inside your system section.
Installing an internal SD card
Before you begin
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
CAUTION
Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
Note: To use an SD card with your system, ensure that the Internal SD Card Port is enabled
in System Setup.
Note: Temporarily label each SD card with its corresponding slot number before removal. Re-
install the SD card(s) into the corresponding slots.
Installing and removing system components
138 Dell PowerEdge R430 Owner's Manual
To Next Page
Loading...
