Entering the system Service Tag by using System Setup
If Easy Restore fails to restore the Service Tag, use System Setup to enter the Service Tag.
Procedure
1. Turn on the system.
2. Press F2 to enter System Setup.
3. Click Service Tag Settings.
4. Enter the Service Tag.
Note: You can enter the Service Tag only when the Service Tag field is empty. Ensure
that you enter the correct Service Tag. After the Service Tag is entered, it cannot be
updated or changed.
5. Click Ok.
6. Import your new or existing iDRAC Enterprise license.
For more information, see the
Integrated Dell Remote Access Controller User's Guide
at
Dell.com/idracmanuals.
Trusted Platform Module
Trusted Platform Module (TPM) is a dedicated microprocessor designed to secure hardware by
integrating cryptographic keys into devices. A software can use a Trusted Platform Module to
authenticate hardware devices. As each TPM chip has a unique and secret RSA key burned in as it
is produced, it can perform the platform authentication.
CAUTION
Do not attempt to remove the Trusted Platform Module (TPM) from the system
board. After the TPM is installed, it is cryptographically bound to that specific system board.
Any attempt to remove an installed TPM breaks the cryptographic binding, and it cannot be
re-installed or installed on another system board.
Note: This is a Field Replaceable Unit (FRU). Removal and installation procedures must be
performed only by Dell certified service technicians.
Installing the Trusted Platform Module
Before you begin
CAUTION
Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
Procedure
1. Locate the TPM connector on the system board.
Note:
To locate the TPM connector on the system board, see the System board
connectors section.
Installing and removing system components
188 Dell PowerEdge R430 Owner's Manual
To Next Page
Loading...
