Note: Depending on the number of installed CPUs, there may be up to four processor
listings.
Number of Cores per Processor
Controls the number of enabled cores in each processor. This option is set to All by default.
Processor 64-bit Support
Specifies if the processor(s) support 64-bit extensions.
Processor Core Speed
Specifies the maximum core frequency of the processor.
Processor 1
Note: Depending on the number of CPUs, there may be up to four processors listed.
The following settings are displayed for each processor installed in the system:
Option
Description
Family-Model-Stepping
Specifies the family, model, and stepping of the processor as defined by Intel.
Brand
Specifies the brand name.
Level 2 Cache
Specifies the total L2 cache.
Level 3 Cache
Specifies the total L3 cache.
Number of Cores
Specifies the number of cores per processor.
SATA Settings
You can use the SATA Settings screen to view the SATA settings of SATA devices and enable
RAID on your system.
Viewing SATA Settings
To view the SATA Settings screen, perform the following steps:
Procedure
1. Turn on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
Note:
If your operating system begins to load before you press F2, wait for the system
to finish booting, and then restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
Pre-operating system management applications
70 Dell PowerEdge R430 Owner's Manual
To Next Page
Loading...
