Dell E70S001 - Drive Backplane Cover; Removing the Drive Backplane Cover

Figure 54. Installing a drive into the drive carrier
Next steps
1. Install the drive carrier.
Rear drive module
Removing the 4 x 2.5-inch rear drive module
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. If required, remove the air shroud.
4. Remove the drives.
5. If installed, remove the BOSS S2 module.
6. Disconnect the cables from the rear drive module.
NOTE: Refer cable routing topic for more information.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws that secures the rear drive module to the system.
2. Lift the rear drive module from the system.
60
Installing and removing system components