Dell E70S001 - Installing the GPU Air Shroud Filler

Cable routing
Figure 65. 12x 3.5-inch SAS/SATA + 2 x 2.5-inch SAS/SATA with APERC in Riser 1 and optional BOSS S2 module
Table 16. 12 x 3.5-inch SAS/SATA + 2 x 2.5-inch SAS/SATA with APERC in Riser 1 and optional BOSS S2
module
From To
SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power connector)
APERC_CTRL_SRC_SA1 (adapter PERC controller
connector)
BP_DST_SA1 (backplane signal connector)
APERC_CTRL_SRC_SB1 (adapter PERC controller
connector)
BP_DST_SA1 (rear backplane signal connector) and
BP_DST_SB1 (backplane signal connector)
BOSS_PWR (BOSS S2 module power connector on system
board)
PWR_1 (BOSS S2 module power connector)
SL6_PCH_PA4 (signal connector on system board) PCIe_1 (BOSS S2 module signal connector)
SIG_PWR_0 (system board power connector) BP_PWR_1 (rear backplane power connector)
Installing and removing system components 69