Dell E70S001 - Installing the Rear Drive Module Air Shroud

Table 18. 12 x 3.5-inch SAS/SATA + 2 x 2.5-inch NVMe with APERC in Riser 1
From To
SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power connector)
APERC_CTRL_SRC_SA1 (adapter PERC controller
connector)
BP_DST_SA1 (backplane signal connector)
APERC_CTRL_SRC_SB1 (adapter PERC controller
connector)
BP_DST_SB1 (backplane signal connector)
SIG_PWR_0 (system board power connector) BP_PWR_1 (rear backplane power connector)
SL7_CPU1_PA5 (signal connector on system board) BP_DST_PA1 (rear backplane signal connector) and
BP_DST_PB1 (rear backplane signal connector)
Figure 68. 12 x 3.5-inch SAS/SATA + 2 x 2.5-inch NVMe with APERC in Riser 2
Table 19. 12 x 3.5-inch SAS/SATA + 2 x 2.5-inch NVMe with APERC in Riser 2
From To
SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power connector)
APERC_CTRL_SRC_SA1 (adapter PERC controller
connector)
BP_DST_SA1 (backplane signal connector)
APERC_CTRL_SRC_SB1 (adapter PERC controller
connector)
BP_DST_SB1 (backplane signal connector)
SIG_PWR_0 (system board power connector) BP_PWR_1 (rear backplane power connector)
SL7_CPU1_PA5 (signal connector on system board) BP_DST_PA1 (rear backplane signal connector) and
BP_DST_PB1 (rear backplane signal connector)
Installing and removing system components 71