Table 21. 12 x 3.5-inch SAS/SATA + 4 x 2.5-inch NVMe with APERC in Riser 2 and optional BOSS S2
module
From To
SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power connector)
APERC_CTRL_SRC_SA1 (adapter PERC controller
connector)
BP_DST_SA1 (backplane signal connector)
APERC_CTRL_SRC_SB1 (adapter PERC controller
connector)
BP_DST_SB1 (backplane signal connector)
BOSS_PWR (BOSS S2 module power connector on system
board)
PWR_1 (BOSS S2 module power connector)
SL6_PCH_PA4 (signal connector on system board) PCIe_1 (BOSS S2 module signal connector)
SIG_PWR_0 (system board power connector) BP_PWR_1 (rear backplane power connector)
SL4_CPU1_PA2 (signal connector on system board) BP_DST_PA1 (rear backplane signal connector) and
BP_DST_PB1 (rear backplane signal connector)
SL7_CPU1_PA5 (signal connector on system board) BP_DST_PA2 (rear backplane signal connector) and
BP_DST_PB2 (rear backplane signal connector)
Figure 71. 8 x 2.5-inch SAS with NVMe and fPERC
Table 22. 8 x 2.5-inch SAS with NVMe and fPERC
From To
SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power connector)
SL1_CPU2_PB1 (signal connector on system board) BP_DST_PA1 (backplane signal connector)
SL2_CPU2_PA1 (signal connector on system board) BP_DST_PB1 (backplane signal connector)
SL3_CPU1_PB2 (signal connector on system board) and
SL4_CPU1_PA2 (signal connector on system board)
BP_DST_PA2 (backplane signal connector) and BP_DST_PB2
(backplane signal connector)
SL7_CPU1_PA5 (signal connector on system board) CTRL_DST_PA1 (fPERC input connector)
Installing and removing system components 73
To Next Page
Loading...
