Figure 55. Removing the 4 x 2.5-inch rear drive module
Next steps
1. Replace the 4 x 2.5-inch rear drive module.
Installing the 4 x 2.5-inch rear drive module
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. If required, remove the air shroud.
4. Remove the drives.
5. If installed, remove the BOSS S2 module.
6. Disconnect the cables from the rear drive module.
NOTE: Refer cable routing topic for more information.
Steps
1. Align and lower the rear drive module with the guide on the system board.
2. Using a Phillips #2 screwdriver, tighten the captive screws that secures the rear drive module into the system.
Installing and removing system components
61
To Next Page
Loading...
