Steps
1. Hold the system board holder and plunger, lower the system board at a tilted angle into the computer.
2. Slide the system board towards the rear of the chassis until the connectors are firmly seated in the slots.
3. Connect all the cables to the systemboard.
Next steps
1. Install the processors and heat-sink module.
2. Install the riser card 4.
3. Install the riser card 3.
4. Install the riser card 2.
5. Install the riser card 1.
6. Install the memory module.
7. Install the right wall bracket.
8. Install the left wall bracket.
9. Install the right control panel.
10. Install the left control panel.
11. Install the cooling fan assembly.
12. Install the air shroud.
13. Install the system cover.
82
Removing and installing components
To Next Page
Loading...
