Dell EMC Edge 3200 - System Shutdown and Restart; Configure LAN Network

Table 3. I2C and GPIO names and pin mappings (continued)
S No. Peripheral detail Hardware signal name Name/Number to use
with RHProxy
Comments
7 GPIO Pin 6 User LED 1 6 -
8 GPIO Pin 7 User LED 2 7 -
9 GPIO Pin 8 User LED 3 8 I2C0 (CN43) interrupt pin
10 GPIO Pin 9 DI0 9
11 GPIO Pin 10 DI1 10 -
12 GPIO Pin 11 DI2 11 -
13 GPIO Pin 12 DI3 12 -
14 GPIO Pin 13 DI4 13 -
15 GPIO Pin 14 DI5 14 -
16 GPIO Pin 15 DO4 15 -
17 GPIO Pin 16 DO5 16 -
System shutdown and restart
Steps
1. Click the Start icon.
2. Click Power, then select Restart or Shut down.
Configure LAN network
Steps
1. Connect an Ethernet cable to the Ethernet port.
The following prompt is displayed:
Figure 6. Prompt for discoverable in network
2. Select Yes.
Setting Up the Windows 10 Operating System
13