About this task
In this task, the user sends an OOB command from the Azure IoT Central portal.
Steps
1. After provisioning and connecting the device to the Azure IoT Central portal, the device status changes to provisioned.
2. Click on the device and then navigate to the following for more information:
a. Overview: To view the Device Properties.
Figure 54. Overview
b. Commands: to send OOB power control commands to the device.
3. The OOB service, enabled through the PSE, allows the user to execute the following commands:
● Reboot: Reboots platform.
● Shutdown: Puts the platform in a low power state.
● Power Up: Brings the platform out of low power state.
● Decommission: Un-registers the platform, withdrawing the device from remote management using the cloud.
54
Setting Up the Windows 10 Operating System
To Next Page
Loading...
