Table 6. Rear view of the system with 2 x 2.5-inch rear drive module
Item Ports, panels, or slots Icon Description
cards that are supported on your system, see www.dell.com/
poweredgemanuals section.
8 Power supply unit (PSU
2)
For more information about the PSU configurations, see the
www.dell.com/poweredgemanuals section.
9
VGA port Enables you to connect a display device to the system. For more
information, see the www.dell.com/poweredgemanuals section.
10 USB 3.0 port (1) This port is USB 3.0-compliant.
11 iDRAC dedicated port Enables you to remotely access iDRAC. For more information, see
the iDRAC User's Guide at www.dell.com/poweredgemanuals
12 System identification
button
Press the system ID button:
● To locate a particular system within a rack.
● To turn the system ID on or off.
To reset iDRAC, press and hold the button for more than 16
seconds.
NOTE:
● To reset iDRAC using system ID, ensure that the system ID
button is enabled in the iDRAC setup.
● If the system stops responding during POST, press and hold
the system ID button (for more than 5 seconds) to enter
the BIOS progress mode.
13
OCP NIC port (optional) N/A This port supports OCP 3.0. The NIC ports are integrated on the
OCP card which is connected to the system board.
14 NIC port (1,2) The NIC ports are embedded on the LOM card that is connected to
the system board.
15 Power supply unit (PSU 1) For more information about the PSU configurations, see the
www.dell.com/poweredgemanuals section.
For more information about the ports, see the www.dell.com/poweredgemanuals section.
System overview
15
To Next Page
Loading...
