Figure 62. 16 x 2.5-inch drive backplane
1. BP_DST_SB1 (backplane to front PERC) 2. BP_PWR_1 (backplane power and signal cable to system
board)
3. BP_PWR_CTRL (front PERC power and control signal) 4. BP_DST_SA1 (backplane to front PERC)
Figure 63. 24 x 2.5-inch drive backplane
1.
DST_PB6 (PCIe/NVMe connector) 2. DST_PA6 (PCIe/NVMe connector)
3. DST_PB5 (PCIe/NVMe connector) 4. DST_PWR_2 (backplane power and signal cable to system
board)
5. DST_PA5 (PCIe/NVMe connector) 6. DST_PB4 (PCIe/NVMe connector)
7. DST_PA4 (PCIe/NVMe connector) 8. DST_PB3 (PCIe/NVMe connector)
9. DST_PA3 (PCIe/NVMe connector) 10. DST_PB2 (PCIe/NVMe connector)
11. DST_PWR_1 (backplane power and signal cable to system
board)
12. DST_PA2 (PCIe/NVMe connector)
13. DST_PB1 (PCIe/NVMe connector) 14. DST_PA1 (PCIe/NVMe connector)
Removing the drive backplane
Prerequisites
CAUTION:
To prevent damage to the drives and backplane, remove the drives from the system before removing
the backplane.
CAUTION: Note the number of each drive and temporarily label them before you remove the drive so that you
can reinstall them in the same location.
NOTE: The procedure to remove the backplane is similar for all backplane configurations.
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the backplane cover.
4. If installed,remove the air shroud.
5. Remove all the drives.
6. Remove the cooling fan cage assembly.
7. Disconnect the drive backplane cables from the connector on the system board.
8. Disconnect the drive backplane cables from the connector on the backplane.
64
Installing and removing system components
To Next Page
Loading...
