Dell EMC PowerEdge R7525 - Page 174

Table 36. GPU power cable matrix
Category Description Type Vendor Cable Cable quantity
GPU CRD,GRPHC,NVIDIA,
24GB,RTX6000
FH and FL NVIDIA 8 pin cable 1 piece per GPU riser
GPU CRD,GRPHC,NVIDIA,
48GB,RTX8000
FH and FL NVIDIA 8 pin cable 1 piece per GPU riser
FPGA Xilinx Snow White
Card
FH and FL Xilinx 6 + 2 pin cable 1 piece per GPU riser
HH - Half Height, HL - Half Length, FH - Full Height, FL - Full Length
NOTE: Maximum of three full length GPUs with power cables or a maximum of six half lengths GPUs are supported in a
system.
7. To connect the XGMI cable,
a. Connect the MB_SL1 and MB_SL2 connectors on the XGMI cable to the J_SL1 and J_SL2 connectors on the system
board.
b. Twist the cable to 180 degrees to connect the MB_SL3 and MB_SL4 to the J_SL3 and J_SL4 connectors on the system
board.
c. Install the cable tie and tighten to fix the cables.
d. To know the XGMI cable connectors on the system board, refer to the System board jumpers and connectors topic.
8. Install the full length expansion card riser or half height expansion card riser. See GPU kit components table for supported
GPU risers.
9. Install the GPU air shroud top cover.
10. Install the foam on the system cover. To install the foam,
a. Place the system cover with the System Information Lable (SIL) side facing up.
b. For easier handling, peel off a small section of the adhesive cover and align the foam with the system cover.
c. Remove rest of the adhesive cover, and install foam on the system cover.
d. Press along the length of the foam to ensure that it is firmly affixed to the system cover.
174
Upgrade Kits