Figure 128. Unplugging the power cord from an AC power supply/cooling module
3. On a DC power/cooling module, pinch the spring releases on each side of the power cord plug and pull the plug out of the
connector.
Figure 129. Unplugging the power cord from a DC power supply/cooling module
4. Remove the power/cooling module as follows:
a. Press the orange handle button to release the module.
b. Pull the latch outward, and remove the power/cooling module from its slot.
CAUTION:
To protect a running system from overheating, the enclosure powers down unless you replace
the power cooling module within two minutes.
Expansion enclosure service procedures 103
To Next Page
Loading...
