Figure 120. Installing a drive
The activity light flashes to indicate that the spin-up sequence has begun.
Installing the front bezel
Steps
1. Align the bezel with the enclosure.
2. Gently push the bezel into place on the cabinet until it latches.
3. If the bezel has a key lock, lock the bezel with the provided key.
Figure 121. Installing the bezel
Verify the operation of a replacement drive
Steps
1. From PowerStore Manager, select Hardware.
2. Select the appliance where you replaced the drive.
3. On the Components card, under Drives, expand ExpansionEnclosure and select the drive.
96
Expansion enclosure service procedures
To Next Page
Loading...
