2. Ship the failed part to your service provider as described in the instructions that were included with the replacement part.
3. For more information about returning customer-replaceable parts:
a. Open PowerStore Manager.
b. Click Settings on the upper right of the screen.
c. Click General Support.
d. Under Drives, Power Supplies, and Other Parts, click Return Part.
e. If your screen does not show the Return Part link, contact your service provider for instructions.
Replace an embedded module
Take the following actions to remove the faulted embedded module and install the replacement embedded module into the
system.
Identify a faulted embedded module from PowerStore Manager
Before you replace an embedded module, ensure that you have identified its location within the system. Using PowerStore
Manager, you can identify and locate a faulted embedded module.
Steps
1. From PowerStore Manager, select Hardware.
2. Select the appliance that includes the embedded module that you need to replace.
3. On the Components card, under Rear View, expand BaseEnclosure.
4. Expand the node that includes the embedded module, and then select EmbeddedModule.
Faulted parts appear in red in the image of the system, and report a status of Faulted in the State field.
Embedded module LEDs
Use the fault LEDs to identify the faulted part.
Figure 30. Embedded module LEDs
Table 2. Embedded module LEDs
LED Location State Description
Embedded module fault Amber Embedded module has faulted.
Off No fault has occurred, normal operation.
Ethernet port link Green Link established.
Off No link established.
Ethernet port activity Amber blinking Port activity.
Off No port activity.
SAS port and activity link Blue SAS port link is up.
36 Base enclosure service procedures
To Next Page
Loading...
