Figure 2. Installing the system in the enclosure
Cable the base enclosure appliance to switches
For switch cabling information, refer to the PowerStore Networking Guide for PowerStore T Models or PowerStore Networking
Guide for PowerStore X Models.
NOTE: Do not connect the power cables until you have completed network configuration.
Connect power cables
Prerequisites
If you are also installing an expansion enclosure, wait to power up the base enclosure until after you have powered up the
expansion enclosure.
Steps
1. Plug each power cable into the base enclosure power supply.
Figure 3. Inserting the power cable
Install a new base enclosure and optional expansion enclosure
11
To Next Page
Loading...
