The installation process begins.
Figure 26. Installation of ADVA 18.4 operating system begins
2. Continue to monitor the installation process.
When the installation process is complete, the Power down message displays in the installation window.
Figure 27. Installation complete screen
After the ADVA operating system is installed, the system powers off.
Configure BIOS to boot from SSD
1. Power up the VEP1405 series system and press F2 to boot into the BIOS.
2. Using the arrow keys, to go to the Boot tab then press Enter.
3. From the Boot Option Priorities section, select CentOS SATA Flash Drive as Boot Option #1, then press Enter.
Configure BIOS and install ADVA 18.4 operating system installation to SSD
23
To Next Page
Loading...
Need help?
General
