Dell EqualLogic PS-M4110 - Removing the Array from the M1000 e Chassis

Dell EqualLogic PS-M4110 Installation Guide
Array Installation Procedure
15
Array Installation Procedure
To install the PS-M4110 blade array in an M1000e chassis:
1. Remove the retaining clip from the front of the array and the plastic protective covers from the back of the
array.
2. Lift the PS-M4110 array to align it with either a top or bottom slot in the enclosure, supporting the array with
both hands.
If installing the array into a top slot in the M1000e chassis
a. Align the guide rails on the top of the PS-M4110 array with the guide rails at the top of the inside of
M1000e chassis, as shown in Figure 6.
b. Begin to slide the array into the enclosure slot, making sure that the array's guide rails insert into the
guide rails within the M1000e chassis, as shown in Figure 6. When properly inserted, the array should
hang from the enclosure guide rails and slide smoothly into the enclosure.
If installing the array into a bottom slot in the M1000e chassis
a. Align the guide rails on the bottom of the PS-M4110 array with the guide rails at the bottom-inside of
M1000e enclosure, as shown in Figure 7.
b. Begin to slide the array into the M1000e enclosure slot, making sure that the array's guide rails rest on
top of the guide rails within the M1000e enclosure, as shown in Figure 7. Be sure to support the front of
the array as you slide it into the enclosure. When properly inserted, the array should ride on top of the
chassis rails and slide smoothly into the slot.