Dell EqualLogic PS-M4110 Installation Guide
Chapter 4 Configuring the Array
Figure 25: Configure Member – Summary
The array storage is ready to use.
Setting up a Dedicated Management Port
EqualLogic arrays can be managed by the group manager either by using the iSCSI ports, or by using the
dedicated management port on the array.
You can use the Remote Setup Wizard (RSW) on a blade server in the M1000e enclosure and configure or
manage the array using the group manager through the iSCSI ports. However, the IP addresses used for the
iSCSI ports typically are not in the same subnet that is used for the management network. Typically, the M1000e
CMC and external management stations are connected to the management network. Therefore, the CMC and
these management stations are not able to manage the PS-M4110 arrays when using this method. However, the
PS-M4110 arrays can still be managed using the M1000e blade servers on the iSCSI network.
In order for external management systems to manage the PS-M4110 arrays, the dedicated management port on
the M4110 arrays must be configured and placed on the management network’s subnet. In this case, the arrays
are managed using this network only, and cannot be managed using the iSCSI network.
To set up the management port:
1.
Open a telnet (ssh) session on a computer or console that has access to the PS-M4110 array. The array must
be configured beforehand, using one of the procedures described in this manual.
To Next Page
Loading...
