Installation and Setup Configuring the Software
3–10
5. In the Configure Member – RAID Configuration dialog box (Figure 3-5), do
the following and then click
Next.
• Select the RAID policy. You will not be able to select a RAID policy that
is not supported by the array model.
• Optionally, to delay using the member’s storage space until the RAID
verification completes and the batteries are fully charged, select
Wait
until the member storage initialization completes
. By
default, the space is immediately available, although performance will not
be optimal until the RAID verification completes.
Figure 3-5: Configure Member – RAID Configuration
6. In the Configure Member – Summary dialog box (Figure 3-6), click
Finish
if the member configuration is satisfactory. Click Back to make changes.
To Next Page
Loading...
