Virtual Server Networking CLI | 59
hypervisor
Specify the name of a hypervisor session with which VSN will connect.
Syntax
[no] hypervisor name
Parameters
Defaults
None
Command Modes
CONFIGURATION
Command
History
Usage
Information
After you enter the command, you are placed in hypervisor configuration mode to
configure settings for the session.
Enter the
no hypervisor name command to remove the configuration of a specified
hypervisor session from the running configuration and close active hypervisor
sessions without removing the VSN agent from the system.
mode
Set the hypervisor mode used to retrieve configuration information on virtual servers.
Syntax
[no] mode {check | config}
Defaults
config
Parameters
Command Modes
HYPERVISOR
Command
History
name Enter up to 40 characters to specify the name of a hypervisor session
to which you want to connect on network servers.
Version 8.3.8.0 Introduced on the S4810.
Version 8.3.5.1 Introduced on the S55.
Version 8.3.3.4 Introduced on the S60.
check VSN retrieves configuration information about virtual servers from a
hypervisor and notifies the system administrator if the configuration
has changed (for example, a VLAN has been added or removed).
Changes in FTOS configuration parameters must be entered
manually on the switch.
config VSN retrieves configuration information from the Hypervisor and
implements any necessary configuration changes automatically.
Version 8.3.8.0 Introduced on the S4810.
Version 8.3.5.1 Introduced on the S55.
Version 8.3.3.4 Introduced on the S60.
To Next Page
Loading...
Need help?
General
