60 | Virtual Server Networking CLI
www.dell.com | support.dell.com
Usage
Information
You can use the mode command to change the way in which virtual-server
information is retrieved in an existing hypervisor session.
The following log messages are displayed when the hypervisor mode
check is used to
retrieve configuration information on virtual servers:
Message 1
Dec 1 04:57:48: %STKUNIT0-M:CP %VSNMGR-5-VSN_VLAN_DISCOVERY: Te 0/35, Vlan:
4001-4008,4011-4012
Message 2
Dec 1 04:56:46: %STKUNIT0-M:CP %VSNMGR-5-VSN_VLAN_WITHDRAWAL: Te 0/35, Vlan:
4001-4008,4011-4012
package install
Install an Open Automation package, such as Virtual Server Networking. This
command downloads the package from the specified location, and installs it in the
internal flash memory on a switch.
Syntax
package install location
Parameters
Defaults
None
Command Modes
EXEC Privilege
Command
History
Usage
Information
Because the installation of the VSN package takes time, the installation is performed
in the background. When the download is complete, a message is displayed on the
console.
To follow the progress of a package installation, enter the show packages command.
location Enter the location where you want to install an Open Automation
package, where location is one of the following values:
• flash://filename installs the VSN package file stored in flash
memory on the switch.
• ftp://userid:password@host-ip-address/file-path logs in and
installs VSN from a file stored on an FTP server.
• tftp://host-ip-address/file-path installs VSN from a file stored on
a TFTP server.
Version 8.3.8.0 Introduced on the S4810.
Version 8.3.5.1 Introduced on the S55.
Version 8.3.3.4 Introduced on the S60.
To Next Page
Loading...
Need help?
General
