Dell G0N7D - Installing the BOSS S2 Module Blank

Figure 59. Removing the BOSS S2 module blank
Next steps
1. Replace the BOSS S2 module blank or install BOSS S2 card module.
Installing the BOSS S2 module blank
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the front bezel.
Steps
1. Align and slide the BOSS S2 module blank into the system bay.
2. Hold the BOSS S2 module blank into its place and tighten the captive screw.
72
Installing and removing system components