60 System Board
12
Disconnect the DC-in connector cable from the connector on the system
board.
13
Remove the three screws that secure the system board to the computer
base.
14
Carefully ease the connectors on the system board out of the slots in the
computer, and lift the system board out of the computer.
15
Turn the system-board assembly over.
16
Remove the heat-sink assembly. See "Removing the Heat-Sink Assembly"
on page 63.
Replacing the System Board
1
Follow the instructions in "Before You Begin" on page 9.
1 DC-in connector cable 2 screws (3)
To Next Page
Loading...
