DC-in Cable 79
18
DC-in Cable
WARNING: Before working inside your computer, read the safety information
that shipped with your computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your
computer. Damage due to servicing that is not authorized by Dell is not covered by
your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery
(see "Removing the Battery" on page 13) before working inside the computer.
Removing the DC-in Cable
1
Follow the instructions in "Before You Begin" on page 9.
2
Remove the battery. See "Removing the Battery" on page 13.
3
Remove the module cover. See "Removing the Module Cover" on page 15.
4
Remove the keyboard. See "Removing the Keyboard" on page 25.
5
Remove the palm-rest assembly. See "Removing the Palm-Rest Assembly"
on page 29.
6
Remove the display assembly. See "Removing the Display Assembly" on
page 42.
7
Remove the screw that secures the DC-in assembly to the computer base.
To Next Page
Loading...
