80 DC-in Cable
8
Disconnect the DC-in connector cable from the connector on the system
board.
9
Note the routing of the DC-in connector cable and lift the DC-in
connector off the computer base.
Replacing the DC-in Cable
1
Follow the instructions in "Before You Begin" on page 9.
2
Route the DC-in connector cable and place the DC-in connector on the
computer base.
3
Connect the DC-in connector cable to the connector on the system board.
4
Replace the screw that secures the DC-in connector assembly.
1 screw 2 DC-in connector cable
To Next Page
Loading...
