Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display cable and provides a visual representation of the installation procedure.
Figure 84. Installing the display cable
Steps
1. Adhere the display eDP cable to the display back-cover and antenna assembly.
2. Connect the display eDP cable to the connector on the camera module.
Next steps
1. Install the display panel.
2. Install the display bezel.
3. Install the display assembly.
4. Install the wireless card.
5. Install the solid-state drive.
6. Install the base cover (plastic chassis).
7. Follow the procedure in After working inside your computer.
104
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
