6. Replace the screw (M2x3) to secure the wireless card and the wireless-card bracket to the system board.
Next steps
1. Install the base cover (plastic chassis) or the base cover (aluminum chassis), whichever is applicable.
2. Follow the procedure in After working inside your computer.
Fan
Removing the fan
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover (plastic chassis) or the base cover (aluminum chassis), whichever is applicable.
About this task
The following image indicates the location of the fan and provides a visual representation of the removal procedure.
Figure 30. Removing the fan
Steps
1. Disconnect the fan cable from the connector (FAN1) on the system board.
2. Remove the two screws (M2x4) that secure the fan to the palm-rest and keyboard assembly.
3. Lift the fan off the palm-rest and keyboard assembly.
Removing and installing Customer Replaceable Units (CRUs)
51
To Next Page
Loading...
