Figure 33. Installing the 3-cell battery
Steps
1. Place the 3-cell battery, along with the battery cable, in the slot on the palm-rest and keyboard assembly.
2. Align the screw holes on the 3-cell battery with the screw holes on the palm-rest and keyboard assembly.
3. Replace the three screws (M2x3) to secure the 3-cell battery to the palm-rest and keyboard assembly.
Next steps
1. Install the base cover (plastic chassis) or the base cover (aluminum chassis), whichever is applicable.
2. Follow the procedure in After working inside your computer.
Removing the 4-cell battery
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover (plastic chassis) or the base cover (aluminum chassis), whichever is applicable.
About this task
The following image indicates the location of the 4-cell battery and provides a visual representation of the removal procedure.
Removing and installing Field Replaceable Units (FRUs)
55
To Next Page
Loading...
