Figure 55. Installing the I/O-board cable
Steps
1. Place the I/O-board cable on the palm-rest and keyboard assembly.
NOTE:
For computers shipped with a plastic chassis, carefully slide the I/O-board cable underneath the wireless-
antenna cables to place the I/O-board cable on the palm-rest and keyboard assembly.
2. Connect the I/O-board cable to the connector on the I/O board and close the latch.
3. Connect the I/O-board cable to the connector (IOBD1) on the system board and close the latch.
Next steps
1. Install the fan.
2. Install the base cover (plastic chassis) or the base cover (aluminum chassis), whichever is applicable.
3. Follow the procedure in After working inside your computer.
I/O board
Removing the I/O board
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
Removing and installing Field Replaceable Units (FRUs)
77
To Next Page
Loading...
