Display back-cover and antenna assembly
Removing the display back-cover and antenna assembly (only for
computers shipped with a plastic chassis)
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover (plastic chassis).
3. Remove the solid-state drive.
4. Remove the wireless card.
5. Remove the display assembly.
6. Remove the display bezel.
7. Remove the display panel.
8. Remove the display cable.
9. Remove the camera.
About this task
NOTE:
The display back-cover and antenna assembly cannot be further disassembled once all the Prerequisites
are completed. If the wireless antennas are malfunctioning and are required to be replaced, replace the entire display
back-cover and antenna assembly.
The image below shows the display back-cover and antenna assembly after the Prerequisites have been performed.
Figure 87. Display back-cover and antenna assembly
Removing and installing Field Replaceable Units (FRUs)
107