3. Remove the solid-state drive.
4. Remove the wireless card.
5. Remove the display assembly.
6. Remove the display bezel.
7. Remove the display panel.
About this task
The following image indicates the location of the display cable and provides a visual representation of the removal procedure.
Figure 83. Removing the display cable
Steps
1. Disconnect the display eDP cable from the connector on the camera module.
2. Carefully peel back and remove the display eDP cable from the display back-cover and antenna assembly.
Installing the display cable (only for computers shipped with a
plastic chassis)
CAUTION: The information in this installation section is intended for authorized service technicians only.
Removing and installing Field Replaceable Units (FRUs) 103
To Next Page
Loading...
