Figure 23. Installing the base cover
Steps
1. Connect the battery cable to the connector (BATT1) on the system board.
2. Place the base cover on top of the palm-rest and keyboard assembly.
3. Align the screw holes on the base cover with the screw holes on the palm-rest and keyboard assembly, and snap the base
cover latches into place.
4. Replace the five screws (M2x4) and tighten the two captive screws to secure the base cover to the palm-rest and keyboard
assembly.
Next steps
1. Follow the procedure in After working inside your computer.
Memory module
Removing the memory module
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover (plastic chassis) or the base cover (aluminum chassis), whichever is applicable.
About this task
The following images indicate the location of the memory module and provide a visual representation of the removal procedure.
44
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
