Figure 102. Palm-rest and keyboard assembly
Steps
Place the palm-rest and keyboard assembly on a flat and clean surface and perform the Next steps to install the palm-rest
and keyboard assembly.
Next steps
1. Install the system board.
2. Install the display assembly.
3. Install the power button or the power button with optional fingerprint reader, whichever is applicable.
4. Install the I/O board.
5. Install the I/O-board cable.
6. Install the power-adapter port.
7. Install the touchpad.
8. Install the speakers.
9. Install the heat sink.
10. Install the 3-cell battery or the 4-cell battery, whichever is applicable.
11. Install the fan.
12. Install the wireless card.
13. Install the solid-state drive.
14. Install the memory module.
15. Install the base cover (plastic chassis) or the base cover (aluminum chassis), whichever is applicable.
16. Follow the procedure in After working inside your computer.
120
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
